Suzuki sq-416-420-625 Service Manual page 238

1
L
4) Remove wheel speed sensor from rear axle housing (if
1. Wheel speed sensor
5) Check to ensure that there is clearance between rear wheel
1. Bearing retainer
2. Parking brake shoe
lever
3. Clearance
6) Using special tools (B) & (C) indicated below, draw out axle
7) Rear axle shaft that was drawn out.
8) If equipped with ABS, in order to remove sensor rotor from re-
equipped with ABS).
CAUTION:
D Do not pull wire harness or twist more than necessary
when removing rear wheel speed sensor.
D Do not cause damage to surface of rear wheel speed
sensor or pole piece and do not allow dust, etc. to enter
its installation hole.
bearing retainer and parking brake shoe lever. If no clearance
is found, loosen cable locking nut further to obtain clearance.
shaft.
NOTE:
Use care not to pull brake back plate along with shaft.
CAUTION:
Pull out axle shaft using care so that upper and lower
brake struts and parking cable are not caught.
Special Tool
(C): 09943-35512
(B): 09942-15510
Shaft length "L":
Left side: 711.5 mm (28.0 in.)
Right side: 757.5 mm (29.8 in.)
tainer ring, grind with a grinder one part of the sensor rotor as
illustrated till it becomes thin.
REAR SUSPENSION 3E-11