Suzuki sq-416-420-625 Service Manual page 220

3D-18 FRONT SUSPENSION
"A"
"B"
11) For 4WD vehicle
1. Wheel spindle
2. Drive shaft bearing
INSTALLATION
Reverse removal sequence to install knuckle, wheel spindle oil seal
and drive shaft bearing,noting following points.
Type A Type B
1. Wheel spindle
2. Drive shaft
bearing
3. Front drive shaft
thrust washer
4. Inner oil seal
5. Knuckle cap
6. Drive shaft oil seal
D For 4WD vehicle
Install drive shaft bearing by using special tool.
Special Tool
(A): 09913-76010
(A):
Dimension "a": 0 – 1 mm (0 – 0.04 in.)
Dimension "a":
Dimension "a":
1. Drive shaft bearing
2. Wheel spindle
Dimension "a":
D When installing wheel spindle to knuckle, coat their mating sur-
faces with sealant.
"A": Sealant 99000-31110
D For 4WD vehicle
Also, fill recess in wheel spindle with about 10 g lithium grease.
"B": Grease 99000-25010
Remove drive shaft bearing by using special tool.
Special Tool
(A): 09923-74510
(B): 09930-30102
. . . . . . . .
09913-80112 . . . . . . . .
. . . . . . . . .
1.75 – 2.50 mm (0.069 – 0.098 in.)
. . . . . . . . .
Type A drive shaft thrust washer
Type B drive shaft thrust washer
Type A drive shaft thrust washer
Type B drive shaft thrust washer