Brake Shoe - Suzuki sq-416-420-625 Service Manual

1. Upper shoe return spring
2. Adjuster
3. Pawl lever
4. Adjuster spring
5. Shoe hold down pins
1. Brake back plate
2. Cable cap
3. Brake cable
2) Install brake drum after making sure that inside of brake drum
3) Upon completion of all jobs, depress brake pedal with about 30
4) Tighten rear center console box screws.
5) Install wheel and tighten wheel nuts to specified torque.
6) Check to ensure that brake drum is free from dragging and prop-

BRAKE SHOE

REMOVAL
1) Perform steps 1) to 5) of BRAKE DRUM REMOVAL.
2) Remove shoe hold down springs by turning shoe hold down
3) Remove upper return spring, struts, adjuster, adjuster lever and
4) Remove brake shoes and lower shoe return spring.
6. Shoe hold down
springs
7. Strut spring
8. Lower shoe return
spring
5) Remove brake shoes and disconnect parking brake cable from
and brake shoes are free from dirt and oil.
kg (66 lbs) load three to ten times so as to obtain proper drum-to-
shoe clearance.
Adjust parking brake cable. (For adjustment, refer to PARKING
BRAKE CHECK AND ADJUSTMENT in Section 5.)
Tightening Torque
.
(b): 100 N m (10.0 kg-m, 72.5 lb-ft)
er braking is obtained. Then remove vehicle from hoist and per-
form brake test (foot brake and parking brake).
WARNING:
Use special care when installing brake shoe return
spring. Failure in its proper installation may allow it to
springback and cause personal injury.
pins.
springs.
parking brake shoe lever.
PARKING AND REAR BRAKE 5C-9