Suzuki sq-416-420-625 Service Manual page 629

11) Check for water leakage by pouring water over windshield
through hose. If leakage is found, dry windshield and fill leaky
point with adhesive. If water still leaks even after that, remove
glass and start installation procedure all over again.
CAUTION:
Upon completion of installation, note the following.
D Do not use high pressure water.
D Do not blow compressed air directly at adhesive ap-
plied part when drying.
D Do not use infrared lamp or like for drying.
D Sudden closing of door before adhesive is completely
set may cause glass to become loose or to come off.
Therefore, if door is opened or closed before adhesive
is completely set, make sure to open all door glasses
and use proper care.
D If molding is not securely in place, hold it down with
a tape until adhesive is completely set.
D Each adhesive has its own setting time.
Be sure to refer to its maker's instruction, check set-
ting time of adhesive to be used and observe precau-
tions to be taken before adhesive is set.
D Refrain from driving till adhesive is completely set so
as to ensure proper and sufficient adhesion.
BODY SERVICE 9-11