Suzuki sq-416-420-625 Service Manual page 579

8D-24 WINDOWS, MIRRORS, SECURITY AND LOCKS
STEP
10 Check that hazard warning lights flash with hazard
switch ON.
Is check result OK?
11 Check door knob switch and turn signal relay
circuit referring to its INSPECTION in this section.
Is this circuit OK?
ACTION
POWER DOOR LOCK OPERATION
INSPECTION
1) With the driver side door key turned LOCK, check all power
doors are locked.
2) With the driver side door key turned UNLOCK, check only the
driver side power door is unlocked.
Turn the driver side door key to UNLOCK again within 5 se-
conds, check all power doors are unlocked.
If check result of Step 1) and Step 2) is satisfactory, this operation
is OK.
KEYLESS ENTRY OPERATION
INSPECTION
1) With the IG switch OFF and all doors closed, push LOCK button
on transmitter. Check all power doors are locked.
2) Push UNLOCK button on transmitter. Check only driver side
power door is unlocked.
3) Push UNLOCK button on transmitter again within 5 seconds.
Check all power doors are unlocked.
But if any door is not opened within 30 seconds after power
door(s) unlocked, all power doors are locked again automatical-
ly.
If check result of Step 1) to Step 3) is satisfactory, this operation is
OK.
HAZARD WARNING LIGHTS OPERATION
INSPECTION
1) Check that hazard warning lights flash one time when power
doors are locked by pushing LOCK button on transmitter.
2) Check that hazard warning lights flash two times when power
door(s) is (are) unlocked by pushing UNLOCK button on trans-
mitter.
If check result of Step 1) and Step 2) is satisfactory, this operation
is OK.
YES
Go to Step 11.
Replace controller and
recheck.
NO
Refer to "Turn Signal
and Hazard Warning
Lights" in DIAGNOSIS
and repair.
And go to Step 4.
Repair circuit referring
to WIRING DIAGRAM
MANUAL and recheck.