Suzuki sq-416-420-625 Service Manual page 581

8D-26 WINDOWS, MIRRORS, SECURITY AND LOCKS
IGNITION SWITCH AND DOOR SWITCH CIRCUIT
INSPECTION
1) Disconnect negative cable at battery.
2) Disconnect coupler of power door lock and keyless entry con-
troller, and connect negative cable at battery.
3) Check that the voltage and resistance between following termi-
nals are specifications.
Terminals
When ignition switch is OFF
position
E02-4 and
ground
When ignition switch is ON
position
When all doors are closed
E02-10 and E02 10 and
When any one door is
ground
opened
If check result is satisfactory, this circuit is OK.
DOOR KNOB SWITCH AND TURN SIGNAL RELAY CIRCUIT
INSPECTION
1) Disconnect negative cable at battery.
2) Disconnect coupler of power door lock and keyless entry con-
troller, and connect negative cable at battery.
3) Check that the voltage and resistance between following termi-
nals are specifications.
Terminals
E02-6 and
Anytime
ground
When driver side door lock
knob is pulled up
E02-11 and
ground
When driver side door lock
knob is pushed down
If check result is satisfactory, this circuit is OK.
Condition
Condition
Specification
0 V
10 – 14 V
No continuity
Continuity
Specification
10 – 14 V
Continuity
No continuity