Rear Door Window Regulator - Suzuki sq-416-420-625 Service Manual

9-14 BODY SERVICE
1. Window regulator lubrication points

REAR DOOR WINDOW REGULATOR

REMOVAL
1) Remove door glass, refer to steps 1) to 10) of REAR DOOR
2) Disconnect power window motor lead wire at coupler and clamp.
3) Remove door window regulator attaching nuts (6 pcs.), and take
1. Door window
regulator attaching
nuts
2. Hole
INSPECTION
1) Check regulator sliding and rotating parts for greasing.
2) Check rollers for wear and damage.
3) Check wire for damage.
INSTALLATION
Reverse removal sequence to install door window regulator noting
following points.
D Tighten regulator base nuts according to the order (a, b, c) shown
in figure.
D Adjust door window regulator according to following procedure.
D Securely seal door sealing cover with adhesive.
D Install door window regulator handle (if equipped) so that it has
an angle as shown when glass is fully closed.
1. Door sealing
cover
2. Adhesive
GLASS REMOVAL in this section.
out regulator through hole as shown in left figure.
a. Loosen three nuts, two screws and two bolts.
b. Raise window fully.
c. Tighten three regulator rail nuts according to the order (d, e,
f) shown in figure and two center sash bolts A.
d. Lower window.
e. Tighten two screws B to specified torque. Tighten front screw
first, then rear.
Tightening Torque for glass attaching screws
.
2.5 N m (0.25 kg-m, 1.8 lb-ft)
f. Check that the glass moves up and down smoothly and that
the top part of the glass contacts the glass run evenly.