Suzuki sq-416-420-625 Service Manual page 69

1. Dash panel (engine room)
REMOVAL
WARNING:
Failure to follow the following procedure and WARNING
may cause air bag deployment, personal injury, damage to
parts, or air bag being unable to deploy.
D Never rest a steering column assembly on steering wheel
D When handling the air bag (inflator) modules (driver and
D When grease, cleaning agent. Oil, water, etc. has got onto
1) Disconnect negative (–) cable at battery.
2) Disable air bag system, if equipped. Refer to DISABLING AIR
3) Drain engine coolant and disconnect heater hose (1) from
4) Remove instrument panel, refer to item INSTRUMENT PANEL
5) Remove cooling unit (If equipped).
6) Disconnect rear duct (4) from heater unit.
7) Disconnect heater mode control actuator lead wire (1) at cou-
8) Remove A/C controller (2) (If equipped).
9) Remove SDM (3) (If equipped).
10) Remove heater unit.
2. Nuts
with air bag (inflator) module face down and column verti-
cal.
passenger), be careful not to drop it or apply an impact to
it. If an excessive impact was applied (e.g., dropped from
a height of 91.4 cm (3 feet) or more, never attempt disas-
sembly or repair but replace it with a new one.
air bag (inflator) modules (driver and passenger), wipe off
immediately with a dry cloth.
BAG SYSTEM in Section 10B.
heater unit.
REMOVAL in Section 9.
Refer to item EVAPORATOR (COOLING UNIT) REMOVAL in
Section 1B.
plers.
HEATER AND VENTILATION 1A-17