Suzuki sq-416-420-625 Service Manual page 625

1. Eyeleteer
REMOVAL
1) Clean both inside and outside of glass and around it.
2) Remove wiper arms and garnish.
3) Using tape, cover body surface around glass to prevent any
4) Remove rear view mirror, sunvisor, and front pillar trims (right
5) If necessary, remove instrument panel. Refer to "INSTRU-
6) If necessary, remove head lining. Refer to "HEAD LINING" in
7) If necessary, remove roof trim. Refer to "ROOF TRIM" in this
8) Remove (or cut) windshield molding all around until windshield
9) Drill hole with eyeletter through adhesive and let piano string
10) Cut adhesive all around windshield with piano string.
1. Piano string
2. Windshield
3. Windshield knife
damage.
& left).
MENT PANEL" in this section.
this section.
section.
edge comes out.
through it.
When using tool to cut adhesive, be careful not to cause dam-
age to windshield. Use wire to cut adhesive along lower part of
windshield.
NOTE:
Use piano string as close to glass as possible so as to pre-
vent damage to body and instrument panel.
BODY SERVICE 9-7