Suzuki sq-416-420-625 Service Manual page 240

[A]
[B]
INSTALLATION
Install removed parts in reverse order of removal procedure, noting
the following.
1) Apply grease to oil seal lip as shown and install it to axle shaft.
1. Bearing retainer
2. Oil seal
3. Wheel side
4. Differential side
2) Aligning serrations between new stud bolt(s) and flange, install
1. Stud bolt
2. Nut
3. Washer
4. Flange of axle shaft
3) Install bearing retainer to shaft.
1. Axle shaft
2. Bearing retainer
4) Press-fit wheel bearing and retainer ring as shown.
1
2
[A]: Vehicle without ABS
[B]: Vehicle with ABS
1. Bearing
2. Retainer ring
NOTE:
Amount of grease applied to hollow in oil seal should be
more than 60% of its vacant space.
"A": Grease 99000-25010
new stud bolt(s) by tightening nut as shown.
NOTE:
D Use care not to cause any damage to outside of retainer
ring.
D Refer to figure so that wheel bearing is installed in proper
direction.
REAR SUSPENSION 3E-13