Suzuki sq-416-420-625 Service Manual page 218

3D-16 FRONT SUSPENSION
For 4WD vehicle
For 2WD vehicle
11) Apply sealant and install axle shaft drive flange or hub cap.
D For 4WD vehicle
D For 2WD vehicle
1. Axle shaft drive
flange
2. Bolt
3. Hub cap
4. Wheel hub
12) Install wheel.
Tightening Torque
(a): 100 N
13) For vehicle equipped with ABS, perform driving test referring
to "DRIVING TEST" of "ABS DIAGNOSTIC FLOW TABLE" in
Section 5E or 5E1.
Apply sealant mating surface of axle shaft drive flange, then
install axle shaft drive flange and tighten flange bolt to speci-
fied torque.
Tightening Torque
.
(a): 50 N m (5.0 kg-m, 36.5 lb-ft)
"A": Sealant 99000-31090
Remove grease, old sealant and dusts from mating surfaces
of hub cap and hub to clean, apply water tight sealant "A" to
cap mating surface evenly, and install cap to hub.
"A": Sealant 99000-31090
.
m (10.0 kg-m, 72.5 lb-ft)