Suzuki sq-416-420-625 Service Manual page 263

4A2-4 FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL
2
1
1. Differential side joint
2. Tire lever
3. Front differential assembly
REMOVAL (RIGHT SIDE)
1) Hoist vehicle and remove wheel.
2) Drain differential gear oil.
1. Oil filler / level plug
2. Front drain plug
3) Remove axle shaft drive flange.
4) Remove circlip and front spindle thrust washer.
5) Remove knuckle and wheel hub comp, refer to steps 5) to 7) and
9) to 14) of item COIL SPRING REMOVAL in Section 3D.
1. Circlip
2. Washer
6) Remove drive shaft assembly.
To detach snap ring fitted on the spline of differential side joint
(inboard joint) from differential side gear, pull inboard joint by us-
ing a tire lever.
7) Remove drive shaft thrust washer (to vehicle with G16 or J20 en-
gine) from drive shaft and remove drive shaft oil seal as shown
in figure.
1. Oil seal
CAUTION:
To prevent breakage of boots (wheel side and differential
side), be careful not to bring them into contact with other
parts when removing drive shaft assembly.
CAUTION:
Be careful not to cause damage to drive shaft joint.