Suzuki sq-416-420-625 Service Manual page 631

5) Remove outer weatherstrip.
1. Door outer
weatherstrip
2. Screw
6) Remove glass fitting screws. Then down door glass.
1. Glass
2. Screw
7) Detach rear part of glass run from center sash.
1. Glass run
2. Center sash
3. Partition glass
8) Remove door center sash (by removing two screws with door
1
9) When remove partition glass, slide to front to remove it.
10) Take out glass.
1. Screw
2. Partition glass
3. Center sash
INSTALLATION
Reverse removal sequence to install door glass.
However, be careful of following points.
D Securely seal door sealing cover with adhesive.
D When weatherstrip is hardened, water leak may develop. In such
1. Door sealing
cover
2. Adhesive
CAUTION:
Using a tape-wrapped putty knife (or tape-wrapped
screwdriver), pry off weatherstrip. Use of an unwrapped
tool will cause damage to painting.
glass lowered all the way down).
case, replace it with new one.
BODY SERVICE 9-13