Suzuki sq-416-420-625 Service Manual page 274

4B-4 PROPELLER SHAFTS
"A"
5) Push out bearing race on flange yoke side as described in 1) and
1. Vise
INSPECTION
Inspect propeller shaft and flange yoke for damage, and propeller
shaft for runout.
If damage is found or shaft runout exceeds its limit, replace.
Runout limit: 0.8 mm (0.031 in.)
ASSEMBLY
NOTE:
D Make sure that rollers inside spider bearing race are all in
D Make sure to apply grease to spider bearing race.
1. Spider
2. Bearing
2), and then, holding bearing race in a vise, tap flange yoke and
take out race. (Refer to the figure.)
Remove bearing race on the opposite side in the same way.
NOTE:
D Take care not to lose rollers in spider bearing race when
removing it.
D Fit removed bearings temporarily in spider so that they
can be reinstalled in their original positions.
place.
"A": Grease 99000-25030
CAUTION:
In assembly, be sure to use new circlips, spider and bear-
ings. Reuse of circlips, spider and bearings once as-
sembled is prohibited.