Suzuki sq-416-420-625 Service Manual page 718

10B-12 AIR BAG SYSTEM
1. Data link connector (DLC)
2. DLC cable adapter
3. DLC cable
1
- 1. "AIR BAG"
warning lamp
- 2. "AIR BAG" fuse box
- 3. "AIR BAG"
monitor coupler
3-1. Diagnostic switch
terminal
- 4. Air bag harness
(covered yellow tube)
EXAMPLE: When driver air bag initiator circuit resistance high (Code No.21) is set
Malfunction indicator lamp
("AIR BAG" warning lamp)
Turn ON
Turn OFF
DIAGNOSTIC TROUBLE CODE (DTC) CHECK
[Using SUZUKI scan tool]
1) Turn ignition switch OFF.
2) After setting cartridge to Tech 1, connect it to data link connector
(DLC) located on underside of instrument panel at driver's seat
side.
Special Tool
(A): 09931-76011 (Tech 1)
(B): Mass storage cartridge
(C): 09931-76030
3) Turn ignition switch ON.
4) Read DTC according to instructions displayed on Tech 1 and
print it or write it down. Refer to Tech 1 operator's manual for fur-
ther details.
5) After completing the check, turn ignition switch OFF and discon-
nect Tech 1 from data link connector (DLC).
[Not using SUZUKI scan tool]
1) Check that malfunction indicator lamp ("AIR BAG" warning
lamp) comes ON when ignition switch is turned ON.
If it does not come "ON", proceed to "Table B" on p.10B-18.
2) Using service wire, ground diagnosis switch terminal in monitor
coupler.
3) Read DTC from flashing pattern of malfunction indicator lamp
("AIR BAG" warning lamp). (Refer to "Diagnostic Trouble Code
Table" on p.10B-14 and 10B-15.)
4) After completing the check, turn ignition switch OFF and discon-
nect service wire from "AIR BAG" monitor coupler.
Code No. 21 Code No. 21 Code No. 21
Time (sec.)