Suzuki sq-416-420-625 Service Manual page 264

1. Boot
2. Snap ring
DISASSEMBLY
1) Remove boot band of differential side joint.
2) Slide boot toward the center of shaft and remove snap ring from
outer race, then take shaft out of outer race.
3) Remove circlip and then cage.
4) Remove inside and outside boots from shaft.
CAUTION:
D Do not disassemble wheel side joint (outboard joint). If
D Do not disassemble ball joint of differential side joint.
1. Circlip
2 Snap ring plier
3. Cage
INSPECTION
D Check boots for breakage or deterioration. Replace them as nec-
essary.
D Check circlip, snap ring and boot bands for breakage or deforma-
tion. Replace as necessary.
CLEANING
D Wash disassembled parts (except boots) in degreaser. After
washing, dry parts completely by blowing air.
D Clean boots with cloth. DO NOT wash boots in degreaser, such
as gasoline or kerosene, etc.
Washing in degreaser causes deterioration of boot.
FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL 4A2-5
any malcondition is found in joint, replace it as assem-
bly.
If any malcondition is found in ball joint, replace differ-
ential side joint assembly.