Remove Failed Drive (24-Drive); Install New Drive (24-Drive) - Fujitsu ETERNUS AB Series Maintaining Hardware

What to do next
Go to Remove failed drive

Remove failed drive (24-drive)

You remove a failed drive to replace it with a new one.
Before you begin
• You have an ESD wristband, or you have taken other antistatic precautions.
• You have reviewed the
About this task
When you remove a drive, you must slide the drive partly out of the shelf and wait for the drive to spin down.
Then, you can remove the drive completely.
Procedure
1. Unpack the replacement drive, and set it on a flat, static-free surface near the shelf.
Save all packing materials.
2. Press the release button on the failed drive.
• For drives in HB5100 controller shelves or DE224C drive shelves, the release button is located at the top
of the drive.
The cam handle on the drive springs open partially, and the drive releases from the midplane.
3. Open the cam handle, and slide out the drive slightly.
4. Wait 30 seconds.
5. Using both hands, remove the drive from the shelf.
6. Place the drive on an antistatic, cushioned surface away from magnetic fields.
7. Wait 30 seconds for the software to recognize that the drive has been removed.
Note: If you accidentally remove an active drive, wait at least 30 seconds, and then reinstall it. For the
recovery procedure, refer to the storage management software.
What to do next
Go to Install new drive

Install new drive (24-drive)

You install a new drive to replace the failed one. Install the replacement drive as soon as possible after
removing the failed drive. Otherwise, there is a risk that the equipment might overheat.
Before you begin
• You have a replacement drive that is supported by Fujitsu for your controller shelf or drive shelf.
(24-drive).
Requirements for handling drives
(24-drive).
topic.
| Drives |
44