Sealey VS8626 Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear eye
Refer to
Protection
instructions
1. SaFety
WaRning! ensure that Health and Safety, local authority and general workshop practice regulations are strictly adhered to.
‰
Do not use the tool if it, or any attachment, is damaged.
8
maintain the tool in a good, clean condition for the best and safest performance.
9
If required, ensure that the vehicle to be worked on is adequately supported with axle stands or ramps and is chocked.
9
Put transmission in PARK (automatic transmission) or neUTRAl (manual transmission) and make sure the parking brake is
9
engaged.
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
9
WaRning! Use extreme caution when working around the ignition coil, distributor cap, ignition wires and spark plugs. These
‰
components create hazardous voltages when the engine is running.
Do not connect or disconnect any test equipment with the ignition on, or the engine running.
8
Keep a fire extinguisher nearby that is suitable for petrol/chemical/electrical fires.
9
Account for all tools and parts being used and do not leave any in the engine bay.
9
Keep the tool dry, clean and free from oil, water and grease. Use a mild detergent on a clean cloth to clean the
9
outside of the tool.
Ensure that the vehicle is parked outside, on a non-flammable surface and away from any combustibles.
9
WaRning! The exhaust system could reach temperatures above 300°C. Also exhaust gases are poisonous.
‰
iMPoRtant: Always refer to the vehicle manufacturer's service instructions to establish the current procedure and data. These
instructions are provided as a guide only.
WaRning! The warnings and instructions discussed in this manual cannot cover all possible conditions and situations that may
‰
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
When not in use, store the tool away in its box, in a cool, dry, safe, childproof location.
9
2. intRoDuCtion
essential tool for extinguishing the Particulate Filter light after the filter has been replaced. Also resets the eloYS additive after it has been
topped up and burns any particles that have clogged the filters (regenerate). Powered by connection to the vehicle.
3. FeatuReS
The VS8626 tool:
3.1. Is compatible with the latest CAn vehicles.
3.2. enables Fuel Additive functions for Replacing Filters, resetting
3.3. Additive Reset lights and performing the Regenerate Process.
The new VS8626 Peugeot / Citroen Particulate tool has been designed to extinguish the Particulate Filter
Light after the filter has been replaced, re-set the ELOYS additive light after it has been topped up and also
burn any particles that have clogged the filter (regenerate).
© Jack Sealey limited
DPF RegeneRation & aDDitive Light
tooL - Peugeot/CitRoen
vS8626
model no:
Original Language Version VS8626 Issue 3 (H5F) 04/04/18