Sealey VS7009.V2 Quick Start Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFEtY
WARNING! Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using this
‰
equipment.
Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to this product.
9
maintain the product in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.
9
Use only to pump oils up to SAE 140 viscosity.
9
Ensure safety eye protection and protective clothing are worn when using this product.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Keep children and unauthorised persons away from the working area.
9
Dispose of waste liquids in accordance with local authority regulations.
9
DO NOt use to extract corrosive fluids.
8
DO NOt dismantle, tamper with or adapt the pump for any purpose other than for which it is designed.
8
DO NOt use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
Keep the pump clean and store in a safe, dry, childproof location.
9
WARNING! DO NOt allow uncontrolled discharge of fluids thus polluting the environment.
‰
2. INtRODuctION
manually operated oil dispensing unit manufactured from composite materials. Large visual measurement will identify amount dispensed.
Supplied with a range of five automatic transmission fluid adaptors. Delivers approximately 70ml per stroke. Features a fluid control valve and
adaptor stowage to minimize oil leakage when not in use.
3. SpEcIFIcAtION
model no .............................................................. VS7009.V2
Capacity ............................................................................. 7lt
Hose length .................................................................... 1.5m
4. cONtENtS
Accessories
part no. Description
VS70091 Transmission oil filler adaptor - VAG M30 x 1.5mm
VS70092 Transmission oil filler adaptor - Toyota/Lexus M18 x 1.5mm
VS70093 Transmission oil filler adaptor - VW Passat/Tiguan
VS70090 3pc Transmission oil adaptor set
© Jack Sealey Limited
tRANSMISSION & ENGINE OIL
FILLING SYStEM
VS7009.V2
mODEL NO:
Wear protective
clothing
Original Language Version
Item part no. Description
1 VS7009.A01 Adaptor Ford
2 VS7009.A02 Adaptor universal
3 VS7009.A05 Adaptor VW Audi
4 VS7009.A04 Adaptor VW Audi
5 VS7009.A03 Adaptor VW Audi
VS7009.V2 | Issue:1 12/08/19