Installing The Hydraulic Cylinder - Toro 07068 Operator's Manual

5. Loosen the jam nuts securing the proximity switch to
the frame and lower the switch until it is 2.6 to 4.0 mm
(0.10 to 0.16 inch) from the sensing plate on the hitch
tongue (Figure 4). Tighten the jam nuts to secure the
adjustment.
2
1. Proximity switch
2. Jam nut
3. 2.6 to 4.0 mm (0.10 to 0.16
inch)
4
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1 Rear-actuator tab
4 Bolt (1/2 x 2 inch)
8 Flat washer (.531 x .063)
4 Locknut (1/2 inch)
2 Bolt (3/8 x 1–1/4 inch)
2 Pin assembly
2 Flange nut (3/8 inch)
Procedure
1. Mount the rear actuator tab to the sweeper frame with
4 bolts (1/2 x 2 inch), 8 flat washers (.531 x .063), and
4 locknuts (1/2 inch). Position the components as
shown in Figure 5.
1
2
4
5
G011587
Figure 4
4. Sensing plate
5. Hitch tongue
3
1. Rear actuator tab
2. Secure each end of the hydraulic cylinder to an actuator
tab with a pin assembly, a bolt (3/8 x 1-1/4 inch), and
a flange nut (3/8 inch)
Note: Make sure that the rod end (working end) of
the cylinder is attached to the front actuator tab.
1. Front actuator tab
2. Rear actuator tab
11
Figure 5
2. Sweeper frame
Figure 6).
Figure 6
3. Hydraulic cylinder
4. Pin assembly