Storage - Toro 07068 Operator's Manual

3. Plug each fresh battery into a terminal cradle observing
proper polarity.
Note: If the batteries are improperly installed, the unit
will not be damaged, but it will fail to operate.
4. If you accidentally removed the rubber seal and the
steel gasket, replace them carefully into the channel in
the handheld remote.
5. Replace the cover and secure it with the 6 screws
removed previously (Figure
to 1.7 N-m (13 to 15 in-lb).
Note: Do not over-tighten the screws.
39) and torque them to 1.5

Storage

1. Thoroughly clean the sweeper so it is free of dirt, leaves
and debris.
2. Check the tire pressure. Refer to
Pressure (page 22).
3. Check all fasteners. Tighten as necessary.
4. Grease all grease fittings. Wipe off excess lubricant.
5. Check the condition of the brush. Replace as required.
30
Checking the Tire