ABB Ability Smart Sensor Installation Manual

—
I N S TA L L AT I O N G U I D E
ABB Ability
Installation with mounting putty
ATTENTION
The Smart Sensor should be installed by technically
qualified personnel. Failure to install the sensor in
compliance with applicable codes and regulations
and according to the manufacturer's recommen-
dations may result in electrical shock, fire hazard,
unsatisfactory performance or equipment failure,
and may void the sensor warranty.
WARNING
Only qualified individuals who are familiar with
appropriate national codes, local codes and sound
practices should install, repair or modify electric
motors and/or related accessories. Installation
should conform to appropriate codes and practices.
Failure to follow these instructions could result in
serious personal injury, death and/or property damage.
WARNING
Electrical live circuit hazard. Do not touch electrically
live parts or equipment. Disconnect, lock out and tag
out the motor's power supply before installing or
servicing the sensor.
Smart Sensor for pumps
TM
It is important to read these
instructions in their entirety before
installing the ABB Ability™ Smart
Sensor for pumps.
CAUTION
Surface temperature hazard. The external surface
of an electric motor or the driven pump may reach
temperatures which can cause discomfort, burns
or injury to individuals who come into contact with
the hot surface. For safety reasons the equipment
should be switched off and allowed to cool before
attempting to install the sensor. Equipment surface
temperatures should only be measured with suitable
instruments and not estimated by hand touch or direct
skin contact. Failure to observe this precaution could
result in bodily injury.
CAUTION
Do not replace batteries! Incorrect use of batteries
voids the certifications of the Smart Sensor, such as
safety certifications and IP rating. Dispose of used
sensors according to instructions.