Table of Contents
Advertisement
O c t e l C o m m u n i c a t i o n s
All references to Smooth
Operator pertain to the entire
family of products
Smooth Operator programming
Smooth Operator Configuration Note (77200)
Panasonic DBS
1 0
CPC-B After 3.1
5.11
PROGRAMMING DIRECT CALL (REV 6.0 ONLY)
Direct Call/Auto login programming is different for two and three digit
extensions. Two digit extensions can be programmed directly onto an FF
Key, whereas three digit extensions require a system speedial number to be
programmed.
In the following examples we will use a * as the code for Autologin. This
is reflected in the Smooth Operator system setup.
Programming Autologin for 2 digit extensions: (through phone only)
FF5 FF Key Assignments for Extensions.
Feature = One-Touch VM Access.
PROG AUTO NN *XX#
NN = Smooth Operator pilot number
* = Autologin Code
XX = two digit subscriber extension number.
Repeat this step for all extensions.
Programming Autologin for 3 digit extensions: (through phone only)
Program a Personal speedial (AUTO 90-99) in the following format:
NNN * XXX#
NNN = Smooth Operator pilot number
* = Autologin Code
XXX = three digit subscriber extension number.
Then use the above speedial number:
FF5
FF Key Assignments for Extensions.
Feature = One-Touch VM Access.
PROG AUTO NNN AUTO (90 - 99)
Personal speedial assignment and key assignment must be repeated for all
extensions. The same personal speedial number can be programmed for
each extension.
6.0
CONFIGURING THE SMOOTH OPERATOR
During the install process, run the Integrator program and choose the
Panasonic DBS. The Integrator will place appropriate feature codes into the
Smooth Operator Setup.
The following codes should be inserted by the integrator.
The above information is provided by Octel Communications Corporation as a guide.
C o n f i d e n t i a l
Delayed Ringing.
Controls Call Forward No Answer
Only
See disclaimer on page 1
P a g e
Advertisement
Table of Contents
