English - Philips Airstylist Trio 300 Quick Start Manual

ENGLISH

6
Introduction
This new Philips Beauty Airstylist Trio 300 has been specially designed
to give beautiful styling results in a quick and easy way.
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc. If
you use it in a bathroom, unplug the appliance after use, since the
proximity of water presents a risk, even when the appliance is
switched off.
For additional protection we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grille to make sure it is
not blocked by fluff, hair, etc.
Check the condition of the mains cord regularly. Do not wind the
mains cord round the appliance.
If the mains cord is damaged, the appliance must be discarded.
Always make sure that the attachments are completely dry - on
the inside as well as on the outside - before you connect them to
the styler.
The attachments will become hot during use. Prevent contact
with the skin.
Never block the air grille.
Keep the appliance out of the reach of children.
Always unplug the appliance after use.
Wait until the appliance has cooled down before storing it.
Noise level: L= 74 dB(A) re 1pW