Troubleshooting - Silvercrest SEMK 105 A1 Operating Instructions Manual

Troubleshooting

Malfunction Cause
The plug is not inserted into a
mains power socket.
The appliance is
not working.
The appliance is defective.
There is not enough water in
the water tank .
The "Add water"
The water filter in the water
lamp
tank
lights up.
The pump is defective.
The ice basket
The "Ice full"
The infra red sensors above
lamp
the ice basket
lights up.
The infrared sensors above the
ice basket
The "Add water"
The ice cube tray in the rear
lamp and
part of the appliance is
the "Ice full"
blocked.
lamp
light up.
The water or ambient
temperature is too high.
No ice cubes
are produced.
The cooling system is leaky.
The cooling system is
blocked.
│ GB │ IE
■ 32
is blocked.
is full.
are dirty.
are defective.
Remedy
Connect the plug to the power supply.
Contact the Customer Service
department.
Fill the water tank as described in the
section "Filling the appliance".
Remove any deposits or objects that are
blocking the water filter.
If necessary, you can remove the water filter
by pulling it straight upwards. Replace it
before using the appliance again.
To deal with stubborn deposits, proceed as
described in the section "Cleaning and care".
Contact the Customer Service
department.
Remove some ice cubes from the ice
basket .
Clean the infra red sensors with a soft
cloth.
Contact the Customer Service
department.
Check whether the ice cube tray is
blocked, e.g. by an ice cube, and remove
the blockage.
Pull the plug from the mains socket and
plug it back in again, then restart the
appliance.
Make sure th
♦ at the ambient temperature is
no higher than 32°C.
at the water used is between
♦Make sure th
8 and 25°C.
Contact the Customer Service
department.
Contact the Customer Service
department.
SEMK 105 A1