Silvercrest SHTK 2000 A1 Operating Instructions Manual page 22

Operation
NOTE
► Before use, pull the plug out of the device up to the point indicated with a
red mark!
Heat and blower levels
1) Insert the plug into a power socket .
2) Switch the hair dryer on with the blower level switch 5 .
The hair dryer is fitted with two function switches . With these you can separately
select the strength of the air flow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
0
Heat levels
3) After use, switch the appliance off in that you place the blower level switch 5
into position "0" . Then remove the plug from the wall socket .
4) Press the cord retract button 2 to feed the cord back into the device .
SHTK 2000 A1
The hair dryer is switched off
reduced air flow
full power air flow
cold air flow
low heating level
high heating level
GB │ IE │ 19 ■