Advertisement
Turning the Projector On
1. Turn on your computer or image
source.
2. Remove the lens cover.
On button. After the
3. Press the
status light stays blue, the projector
is ready.
Note: If the Direct Power On function is
enabled, you can turn the projector on
without pressing the
plug it in or flip the switch controlling
the outlet to which the projector is
connected. To turn on this feature, see
the online User's Guide.
If the projector does not turn on, make
sure the power switch on the back of
the projector is turned on.
If your image does not appear, see
"Switching Between Image Sources" or
"Troubleshooting."
Changing the Language of
the Projector Menus
The default language of the projector's
menu system is English, but you can
change it as necessary.
1. Press the Menu button to acess the
projector's menu system.
2. Select Extended > Language.
3. Select your language.
4. When you're done, press the Menu
button to exit.
On button; just
Changing the Projection
Mode
You can change the projection mode
to flip the image over top-to-bottom or
left-to-right using the projector menus.
1. Press the Menu button.
2. Select Extended > Projection.
3. Select a projection mode.
4. When you're done, press the Menu
button to exit.
You can also flip the image over
top-to-bottom by pressing the Shutter
button on the remote control for about
five seconds.
Note: To rotate the menu display, change
the OSD Rotation setting in the Extended >
Display menu.
Switching Between Image
Sources
Press the Search button (remote
control) or one of the source buttons
(remote control or projector).
Changing the Screen Type
Setting
Set the Screen Type setting to the
screen's aspect ratio.
1. Press the Menu button.
2. Select Extended > Display >
Screen > Screen Type.
Advertisement
