Hitachi FDS 10DVA Manual page 4

(b) When assembling the Cap
that the white line on the Cap
21
the Motor . (See Fig. 4)
(c) When assembling the Shift Arm
onto the Spindle Gear Set
that the protruding portions of the Shift
Arm 15 are properly fitted into the
matching grooves of the ring gear
inside the Spindle Gear Set
Fig. 6)
(d) Insert the Shift Spring
(e) Assemble Bit Holder (A)
Housing (A) (B) Set
installed into the insert receiving sockets of the Housings. (See Fig. 8)
Shift Spring
Fig. 7
(f) Mount the components assembled as described in Para. (d) onto the protruding portions of the Shift
Arm 15 that is mounted on the components assembled as described in Para. (a). (See Fig. 9)
Parts assembled in Para. (a)
9 onto the components assembled as described in Para. (a) above, ensure
9
is properly aligned with relation to the colored lead wires soldered to
15
13
, ensure
13
. (See
18 into the Shift Knob
19
and Bit Holder (B)
3
. At this time, ensure that the insert portions of the Bit Holders are properly
Insert Receiving Pocket
17
Shift Knob
Housing (A)
18
Protruding Portion
Shift Arm
Ring Gear
13
Spindle Gear Set
17 . (See Fig. 7)
5 respectively into Housing (A) and Housing (B) of the
Insert Portion
Fig. 8
Shift Arm
Fig.9
−#4 −
15
Grooves
Fig. 6
Bit Holder (A)
Parts assembled in Para. (d)
15
Protruding
Portions
19