Hitachi FDS 10DVA Manual page 5

(g) Mount the components assembled as described in Para. (f) onto the components assembled as
described in Para. (e). At this time, ensure that colored leadwires soldered to the Terminals
properly aligned with relation to Housing (A) and Housing (B). (See Fig. 10)
Parts assembled in Para. (f)
Parts assembled in Para. (e)
(4) Other Precautions on Reassembly:
(a) On completion of reassembly, set the Shift Knob
rotates smoothly when the Drill Chuck
confirm that the Cap
Housing (A)-(B) Set
Confirm that the Drill Chuck
When the Reversing Switch is set to the (R) side, the Drill Chuck
when viewed from the rear (the end opposite from the Drill Chuck).
Also, confirm that the rotation speed of the Drill Chuck
speeds when the Shift Knob
Check the run-out of the Drill Chuck
No. 305-7l3.) mounted in the Drill Chuck
measured at a distance of 50mm from the end of the chuck.
(b) (+) Tapping Screws
(+) Tapping Screws
(+) Bind Screw
(+) Bind Screw
Flat Head Screw
8
Drill Chuck
28
Terminal
Internal Wire (Yellow)
8
9
can be properly aligned with the clutch number positions, marked on the
3
.
8
rotation conforms with the setting position of the Reversing Switch.
17 position is changed.
8 . With a 6mm test bar (Special Repair Tool J-223-2, Code
0.59 - 0.78 N⋅ ⋅ ⋅ ⋅ m (6 - 8 kgf-cm, 5.2. - 6.9 In⋅ ⋅ ⋅ ⋅ Ib)
16
D3 x 8
0.98 - 1.5 N⋅ ⋅ ⋅ ⋅ m (10 - 15 kgf-cm, 8.7 - 13.0 In⋅ ⋅ ⋅ ⋅ Ib)
D3 x 14 4
0.88 - 1.1 N⋅ ⋅ ⋅ ⋅ m (9 - 11 kgf-cm, 7.8 - 11.3 In⋅ ⋅ ⋅ ⋅ Ib)
26
M3.5 x 8
0.88 - 1.1 N⋅ ⋅ ⋅ ⋅ m (9 - 11 kgf-cm, 7.8 - 11.3 In⋅ ⋅ ⋅ ⋅ Ib)
25
M3 x 10
7
M5 x 20
Fig. 10
17
to the "H" position, and confirm that the Spindle
is moved by hand. Also, before turning the Switch ON,
8 changes properly between high and low
8 , ensure that run-out is not more than 0.5mm when
3.9 N⋅ ⋅ ⋅ ⋅ m (40 kgf-cm, 34.7 In⋅ ⋅ ⋅ ⋅ Ib)
3.9 N⋅ ⋅ ⋅ ⋅ m (40 kgf-cm, 34.7 In⋅ ⋅ ⋅ ⋅ Ib)
−#5 −
Internal Wire (White)
Housing (A)
8 must rotate to the right (clockwise)
28 are