Controls System Maintenance; Adjusting The Control-Lever Neutral-Interlock Switch; Adjusting The Control-Lever Neutral Return - Toro Groundsmaster 7210 Series Operator's Manual

Controls System
Maintenance
Adjusting the Control-Lever
Neutral-Interlock Switch
1. Stop the machine, move the motion-control
levers to the N
EUTRAL
parking brake, and remove the ignition key.
2. Remove the bolts securing the front panel and
remove the panel
Figure 82
1. Bolt
2. Control panel
3. Loosen the 2 screws securing the interlock
switch (Figure 83).
- position, engage the
LOCK
(Figure 82).
1. Control lever
2. Neutral-interlock switch
4. Holding the control lever against the frame,
move the switch toward the lever until the
distance between the lever and switch body is
0.4 to 1 mm (0.015 to 0.045 inch) as shown in
Figure 83.
5. Secure the switch.
g020875
6. Repeat steps
7. Install the front panel.
Adjusting the Control-Lever
Neutral Return
If the motion-control levers do not align with the
neutral slots when released from the R
position, adjustment is required. Adjust each lever,
spring, and rod separately.
1. Disengage the PTO, move the control lever to
the N
EUTRAL
parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel
56
Figure 83
3. Screw
4. 0.4 to 1 mm (0.015 to
0.045 inch)
3 to 5 for the other lever.
EVERSE
- position, and engage the
LOCK
LOW
(Figure 84).
g004763
position,