Toro 4045 Installation Instructions Manual page 6

5. Install the bolt (M10-1 x 40 mm), 2 flat washers, and
the hex nut (M10) onto the bracket plate and pivot pin
as shown Box C of
Note: Use the washers to center the bracket and plate.
6. Tighten the hardware as shown in Box D of
7. Torque the bolts (M12) to 80 to 100 N-m (59 to 73
ft-lb).
8. Remove the bolt (M10-1 x 40 mm), 2 flat washers, and
the hex nut from the bracket plate and pivot pin (Box
C of Figure 12).
9. Install the sensor-magnet bolt and hex nut into the
pivot assembly as shown in Box A of
Figure 13
1. Hex nut
2. Sensor-magnet bolt
3. Cotter pins
10. Install the sensor onto the bracket using 2 bolts (M4 x
10 mm) and 2 nuts (M4) as shown in Box B of
13.
Note: Use thread-locking compound on the bolts if
the locknuts are not nylon locknuts.
11. Place the cam assembly in the H
ensure that the notch in the magnetic sensor bolt is
lined up with the wires on the sensor as shown in
Figure 14.
Figure 12.
Figure
Figure 13.
4. Bolts (M4 x 10 mm)
5. Nuts (M4)
position and
OME
12.
12. Ensure that the gap between the magnetic sensor bolt
and the sensor is 0.12 to 0.24 inches.
13. If your bracket does not have a hole, measure in 1 1/14
inch from the edge of the bracket as shown in
15 and drill a 1/4 inch hole.
1. 1 1/4 inch
2. Sensor
Figure
14. Attach the sensor-connector clip to the sensor as
shown in
15. Plug the sensor-connector clip into the hole as shown
in Figure
6
Figure 14
Figure 15
3. Sensor-connector clip
Figure 15.
16.
Figure