Toro 4045 Installation Instructions Manual page 7

Figure 16
1. Sensor
16. Attach the sensor-harness adapter to the sensor as
shown in Figure 16.
17. Connect the sensor-harness adapter to the wiring
harness on the machine.
18. Secure the wiring harness to the R-clamp with a cable
tie as shown in Figure
Figure 17
1. Wiring harness (existing)
19. Torque the bolts to 2.2 to 2.7 N-m (19 to 23 in-lb).
20. Install the elevator cylinder with the 2 cotter pins
included in this kit as shown in Box C of
21. Use the sensor harness adapter to connect the sensor
to the machines wiring harness.
2. Sensor-harness adapter
17.
Figure 13.
4
Removing the Rotary Pump
Supply and Drain Orifices
Parts needed for this procedure:
1 Gasket
Procedure
Important: Allow the engine to cool.
1. Place a drain pan under they rotary pump
2. Cap off the case drain line from the rotary pump to
minimize hydraulic fluid loss.
1. Bolts to be removed
3. Clean the external surface of the rotary pump.
4. Unplug the wiring harness from the pump control.
5. Remove the 6 bolts as shown in
6. Remove the control from the pump housing.
Note: Oil will drain from the case when the housing
is removed.
7. Use needle nose pliers to pull the retaining clip (T40)
from the control
7
Figure 18
2. Cap off the case drain line
Figure 18.
(Figure 19).