Reset Function/Safety Cut-Out; Assembling And Operating The Appliance - Silvercrest SSJBE 300 A1 Operating Instructions Manual

Reset function/Safety cut-out

This appliance is equipped with a safety cut-out to protect the motor.
If fruit pieces get stuck and the appliance turns itself off, the safety cut-out has
tripped. The appliance switches itself off before the motor can be damaged due
to overheating.
The appliance cannot be switched back on until you reset the safety cut-out.
Proceed as follows to be able to use the appliance again:
–
Set the On/Off switch
power cable
for 10–15 minutes.
–
Turn the housing lid
the
–
Remove the housing lid
–
Remove the fruit or vegetable pieces causing the blockage.
–
Carefully remove the sieve tray
–
Insert the plug of the power cable
–
Press the RESET button
base
–
Pull the plug of the power cable
appliance base
–
Reassemble the appliance as described in the following section and
continue with juice extraction.

Assembling and operating the appliance

■ Before using the appliance for the first time, clean all component parts
thoroughly as described in the section "Cleaning and care".
■ Install the appliance in accordance with the safety instructions.
WARNING! RISK OF INJURY!
► Ensure that the plug on the power cable
sembling the appliance.
SSJBE 300 A1
to the "O" position and pull the plug of the
out of the socket. Allow the appliance to cool down
anticlockwise until the
marking on the sieve tray holder
.
that is on the underside of the appliance
.
over.
marking points towards
.
and turn the appliance base
into a mains socket.
out of the socket and turn the
is not in the socket before as-
GB │ IE
over.
│ 41 ■