Fru Replacement; Fru Replacement Procedures; Required Tools And Supplies; Treadmill Shutdown - GE T2100 Service Manual

FRU Replacement

FRU Replacement Procedures

Required Tools and Supplies

To maintain and repair the T2100 Treadmill, you will need the following:
• Standard hand tools, including:
• Socket and Driver set – 9 mm (3/8") or 12 mm (1/2") drive, including extensions
and 9 mm (3/8"), 11 mm (7/16"), 12 mm (1/2"), 14 mm (9/16") sockets
• Wrench set – with opposite "box" and "open" ends in 9 mm (3/8"), 11 mm (7/16"),
12 mm (1/2"), 14 mm (9/16")
• Screwdrivers – small and medium size "flat" tip and "Phillips" tip
• Needle nose pliers
• Crescent Wrench/Channel Locks – 40 mm (1 1/2") minimum
• Hex Key set – 3 mm (1/8"), 4 mm (5/32"), 6 mm (1/4")
• Carpenter's level
• Digital Voltage Ohm Meter (DVOM)
• Leakage current tester PN MT-1216-01 (for 120 V), PN MT-1216-02 (for 240 V), or
equivalent
• CASE Treadmill Interface cable PN 700609-002
• Antiseptic cleaner
• Dust remover (compressed air)

Treadmill Shutdown

This procedure shall be performed prior to replacing any Treadmill FRUs.
• Stop the treadmill by using the controlling device or emergency stop switch when
appropriate.
• Place the ON/OFF switch to the OFF (O) position.
• Disconnect from supply mains by unplugging power cord from wall and T2100.
2021403-120F
T2100 Treadmill
7
105