Table of Contents
Advertisement
TDU Event /
Error Code
0x1a
0x1b
0x1c
2021403-120F
Number
of Red
LED
Flashes
Definition
11
Phase search error
12
Other error
Unknown error code
N/A
T2100 Treadmill
Check These Items
The drive controller has a pre-charge
circuit which must activate after
power-up before the drive controller
can be enabled. If the drive controller
is enabled before this, then the error
occurs. The error could also indicate the
loss of one or more of the input phases.
1.
Powercycle the T-2100 Treadmill
and monitor the T-2100 Treadmill
for reoccurrence of this error. (This
may be an isolated incident.)
2.
Determine if any TDU
Troubleshooting Table errors
are also being reported, and if
so, follow the troubleshooting
procedure for the reported errors.
3.
Replace the drive controller.
Other error code includes four possible
drive faults including: drive power base
fault, drive over-temperature fault,
drive dynamic break overload fault or
commutation loss error.
1.
Measure the resistance of the
dynamic break resistor. Replace if
out of specification.
2.
Verify input voltage to the treadmill
is within range.
3.
Power-cycle the T2100 Treadmill
and monitor the T2100 Treadmill
for reoccurrence of this error. (This
may be an isolated incident.)
4.
Replace the drive controller and
drive motor.
Indicates an unknown condition has
generated an error.
1.
Powercycle the T2100 Treadmill
and monitor the T2100 Treadmill
for reoccurrence of this error. (This
may be an isolated incident.)
2.
Determine if any TDU
Troubleshooting Table errors
are also being reported, and if
so, follow the troubleshooting
procedure for the reported errors.
3.
Replace the drive controller.
Troubleshooting
99
Advertisement
Table of Contents
Troubleshooting
