Drive Motor Replacement - GE T2100 Service Manual

4. Place the new walking board on the T2100 Treadmill with the beveled edges
facing down, towards the rollers.
5. Secure the new walking board to the bed assembly with the 8 Allen-head screws.
6. Replace the walking belt. Use the reverse order used to remove the walking belt
as described in
7. Adjust the walking belt tracking and tension. See
Adjustment" on page
8. Calibrate the T2100 Treadmill. See

Drive Motor Replacement

1. Turn the ON/OFF switch to the OFF position, disconnect the power cord from the
wall outlet, and remove the shroud.
2. Unplug the motor control cable from the drive controller.
3. Unplug the motor power cable from the drive controller.
4. Unscrew the wires from the X1 connector that lead to the motor. See
Controller X1 PIN Descriptions" on page
5. Cut any plastic retaining straps.
6. Loosen the 4 motor mounting bolts, but DO NOT remove them.
2021403-120F
"Walking Belt Replacement Instructions" on page
55.
Item
Description
1
Motor Power Cable
2
Motor Control Cable
T2100 Treadmill
"Walking Belt Tension
"Self-Calibration" on page
121.
FRU Replacement
111.
45.
"Drive
113