Others; Troubleshooting - Panasonic SC-UA30 Operating Instructions Manual

Using the auxiliary input
You can connect a VCR, DVD player etc., and listen to the
audio through this system.
Rear panel
of this unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [SELECT <, >] repeatedly to select "AUX".
3
Play the external equipment.
D-IN mode and AUX mode
1
Press [SELECT <, >] repeatedly to select "D-IN" or
"AUX".
2
Press [PLAY MENU] to select "D-IN MODE" or
"AUX MODE".
3
Press [R, T] to select the mode and then press
[OK].
MODE 1 Select this mode to use the Karaoke effect
function.
MODE 2 Select this mode when watching TV, movies
(default) or using an external player with Karaoke
features.

Others

Auto off
This system automatically switches off when you do not
use it for approximately 20 minutes.
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
• This function does not work when you are in radio source or
when a Bluetooth
device is connected.
®
• This function may not work when a microphone is connected.
DVD player (not supplied)
Bluetooth standby
®
This function automatically switches on the system when
you establish a Bluetooth
®
device.
1
Press [SETUP] repeatedly to select "BLUETOOTH
STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth device before switching off the
®
system, wait for a minimum of 5 seconds before connecting to
this system from your Bluetooth
Software update
Occasionally, Panasonic may release updated software
for this unit that may add or improve the way a feature
operates. These updates are available free of charge. For
more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
█ Checking the software version
1
Press [SETUP] repeatedly to select "SW VER."
and then press [OK].
The software version is shown.
2
Press [OK] again to exit.

Troubleshooting

Before requesting service, make the following checks. If
you are in doubt about some of the check points, or if the
solutions indicated do not solve the problem, consult your
dealer for instructions.
█ Common problems
The unit does not work.
• The safety device has been activated. Do the following:
1. Press [1] on the unit to switch the unit to standby mode.
If the unit does not switch to standby mode, disconnect
the AC mains lead and then connect it again.
2. Press [1] again to switch on the unit. If the problem
persists, consult your dealer.
The display panel lights up and changes continuously in
standby mode.
• Press and hold [8] on the unit to select "DEMO OFF".
No operations can be done with the remote control.
• Examine that the battery is installed correctly.
Sound is distorted or no sound.
• Adjust the volume of the system.
• Switch off the system, determine and correct the cause, and
then switch on again. It can be caused by straining of the
speakers through excessive volume or power, and when
using the system in a hot environment.
connection from a paired
device again.
®
13
13