Preparing Media - Panasonic SC-UA30 Operating Instructions Manual

Preparing media

USB
Preparation
Before you connect a USB device to the system, make
sure you do a backup of the data.
1
Decrease the volume and connect the USB device
to the USB port.
2
Press [SELECT <, >] repeatedly to select "USB".
Note:
• Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
• Some devices cannot be charged as the maximum USB
charging current is 0.5 A only.
Bluetooth
®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the unit.
• Switch on the Bluetooth
®
the device near the system.
• Read the operating instructions of the device for details.
█ Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it ( 7).
1
Press [ ].
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING" and then
press [OK].
3
Select "SC-UA30" from the Bluetooth
device.
If prompted for a passkey, input "0000" or "1234".
The device connects with this system automatically
after pairing is complete.
The MAC address (example: 6C:5A:B5:B3:1D:0F)
may be shown before "SC-UA30" is shown.
The name of the connected device is shown for a few
seconds.
feature of the device and put
device,
®
menu of the
®
Using the unit
1
Press and hold [ ] until "PAIRING" is shown.
2
Select "SC-UA30" from the Bluetooth
device.
Note:
• You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
• Depending on the searching functionality of the Bluetooth
device and the surrounding environment, if the product
name is not shown on the Bluetooth
switch off and then switch on the Bluetooth
device repeatedly during the pairing process.
█ Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it ( 7).
1
Press [ ].
"BLUETOOTH READY" is shown.
2
Select "SC-UA30" from the Bluetooth
device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
• A device must be paired to connect.
• This system can only connect to one device at a time.
• When "BLUETOOTH" is selected as the source, this system
will automatically try to connect to the last connected device.
("LINKING" is shown during this process.)
█ Disconnecting a device
While a Bluetooth device is connected
®
1
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
2
Press [R, T] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the unit
Press and hold [ ] until "PAIRING" is shown.
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
• Disable the Bluetooth transmission of the device.
®
• Switch off the system or the device.
menu of the
®
®
menu of the device,
®
feature of the
®
device,
®
menu of the
®
7
7