Specifications - Panasonic SC-UA30 Operating Instructions Manual

"USB OVER CURRENT ERROR"
• The USB device is drawing too much power. Disconnect the
USB device, switch off the system and then switch on again.
• Check the connection, it may be caused by a faulty USB
cable.
"VBR"
• The system cannot show the remaining play time for variable
bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [SELECT] repeatedly on the unit to select "AUX".
█ To set the code to "REMOTE 2"
1
Press and hold [SELECT] on the unit and [<] until
"REMOTE 2" is shown.
2
Press and hold [OK] and [<] for a minimum of
4 seconds.
█ To set the code to "REMOTE 1"
1
Press and hold [SELECT] on the unit and [
the remote control until "REMOTE 1" is shown.
2
Press and hold [OK] and [
control for a minimum of 4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC mains lead.
2
While you press and hold [1] on the unit,
connect the AC mains lead again.
Continue to press and hold the button until
"– – – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
] on
] on the remote

Specifications

█ General
Power supply
Power consumption
Power consumption in standby mode (approximate)
With "BLUETOOTH STANDBY" set to "OFF"
With "BLUETOOTH STANDBY" set to "ON"
Dimensions (W x H x D)
Mass
Operating temperature range
Operating humidity range
20% to 80% RH (no condensation)
█ Amplifier section
RMS output power
Front Ch (x 2 channel)
150 W per channel (4 Ω), 1 kHz, 30% THD
Total RMS power
█ Tuner, terminals section
Frequency modulation (FM)
Preset memory
Frequency range
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals
Digital audio input
Optical digital input
Sampling frequency 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Audio format
Analog audio input
Audio input
Microphone
Terminal
█ USB section
USB port
USB standard
Media file format support
USB device file system
AC 220 V to 240 V, 50 Hz
51 W
0.5 W
0.6 W
265 mm x 606 mm x 272 mm
0°C to +40°C
300 W
30 stations
75 Ω (unbalanced)
Optical terminal
PCM
Pin jack (1 system)
Mono, 6.3 mm jack (2 system)
USB 2.0 full speed
MP3 (*.mp3)
FAT12, FAT16, FAT32
8 kg
15
15