Philips CoralCare Software Manual page 3

After connection to the controller is made, the software will check the firmware of the controller. If a new version
is available, the software will show the following message:
Please note that a firmware update might take some time before it is successfully uploaded to the controller.
After the firmware check, the software will start loading the settings from the controller and will check if the time
is programmed correctly. If this is out-of-sync with the time settings of your desktop, the software will load the
"Set device time" screen
Press refresh to check the time which is programmed in the controller. If you want to change the time, you can
enter a custom day and time manually or synchronize the time with your computer. Make sure to check your
time zone and turn on daylight saving if this is applicable for your region. If you want to access the time settings
again navigate to device --> Set device time
3/12