Mitsubishi Electric 800 Series Instruction Manual page 13

4.
Remove the body screws of the inverter, then install the hexagon spacers to the inverter (tightening torque 0.33 to 0.40
N·m).
5.
Fit the junction connector, which has been connected to the plug-in option, to the guide of the option connector on the
inverter, and insert the junction connector as far as it goes.
6.
Fasten this product to the inverter using the two mounting screws through the holes on either side (tightening torque 0.33
to 0.40 N·m). If the connector is not inserted deep enough, the screws cannot be tightened properly. Check the
connector.
7.
Connect cables to the terminal block of the plug-in option. (Refer to
8.
After wiring of the plug-in option has been completed, mount the front cover for the plug-in option to the inverter.
5. Plug-in option
6. Mounting
screw
8. Recessed
neck screw
12
INSTALLATION
3. Junction connector
3. Straight spacer
4. Hexagon spacer
6. Mounting screw
8. Front cover for plug-in option
page 19 for the wiring.)
4. Hexagon spacer
3. L-shaped spacer