Yamaha Clavinova CLP-230 Owner's Manual page 66

CLP-240/230: Keyboard Stand Assembly
2.
Attach B.
2-1
Place the bottom edges of B on the feet's protrud-
ing edges of D and E, then, secure the top part in
alignment with the protruding edges.
2-2
Temporarily secure the top part using 4 x 12 mm
thin screws.
2-3
2-3
Temporarily secure the bottom part using four 4
x 20 mm tapping screws.
2-4
If you assembled the stand on an unlevel surface,
place the assemble stand on a level surface.
3.
Mount A.
3-1
Assemble the side panel protection (cardboard)
pad, as shown in the illustration. Then, remove
the two backing papers from the adhesive tape on
the protection pad.
66
CLP-240/230 Owner's Manual
2-2
3-2
Cover the top of D and E with the side panel pro-
tection pad. Then, fix the protection pad with the
adhesive tape.
3-3
Align the dimple on side A with the inner side of
D and E. Simultaneously lower the left and right
side of A, and secure with D and E.
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
Place your hands at least
10 cm from either end of
A when positioning it.
3-4
Support the backside of D and E with your hand,
and slightly push A in from the keyboard side
until it stops.
3-5
Remove the side panel protection pad.