Table of Contents
Advertisement
position. When the component is in the correct
position, a triangle lights up in the corresponding
square
(Figure
9).
1. Triangles light up when the interlock components are in the
correct position.
Testing the Safety-Interlock
System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the
machine each time.
Note:
If the safety system does not operate as
described below, have an Authorized Service Dealer
repair the safety system immediately.
1.
Start the engine; refer to
(page
17).
2.
Move the motion-control levers to the center,
unlocked position.
Note:
The attachment should stop and the
engine should stop running.
3.
Start the engine and disengage the parking
brake.
4.
Move either motion-control lever to the center,
unlocked position.
5.
Continue holding the motion-control lever in the
center, unlocked position, pull up on the PTO
switch, and release the switch.
Note:
The clutch and attachment should
engage.
6.
Move or release the motion-control levers into
the N
-
EUTRAL
LOCK
Note:
The attachment should stop and the
engine should continue to run.
7.
Push the PTO switch down and move either
motion-control lever to the center, unlocked
position.
Figure 9
Starting the Engine
position.
8.
Continue holding the motion-control lever in the
center, unlocked position, pull up on the PTO
switch, and release the switch.
Note:
The clutch and attachment should
engage.
9.
Push the PTO switch down to the O
Note:
The attachment should stop.
10.
With the engine running, pull up the PTO
switch and release it without holding either
motion-control lever to the center, unlocked
position.
Note:
The attachment should not engage.
g031282
WARNING
The operator platform is heavy and may cause
injury when you raise or lower it. Carefully
lower or raise the operator platform, as
suddenly dropping it could injure you.
• Do not put your hands or fingers in the
platform-pivot area when lowering or
raising the operator platform.
• Make sure that the platform is supported
when you pull the latch pin out.
• Make sure that the latch secures the
platform when folding it up. Push it tight
against the cushion for the latch pin to
lock into place.
• Keep bystanders away from the machine
when raising or lowering the platform.
14
position.
FF
Advertisement
Table of Contents
