Table of Contents
Advertisement
Servicing the Fuel Filter
Replacing the Fuel Filter
Service Interval: Every 800 hours/Yearly (whichever
comes first)
Do not install a dirty filter if it is removed from the fuel
line.
Note:
Wipe up any spilled fuel.
1.
Disengage the PTO and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Close the fuel-shutoff valve; refer to
Fuel-Shutoff Valve (page
4.
Replace the fuel filter as shown in
Figure 45
Using the
21).
Figure
45.
g027518
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the battery or remove the spark-plug
wire before making any repairs. Disconnect the
negative terminal first and the positive terminal
last. Connect the positive terminal first and
negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Servicing the Battery
Service Interval: Every 100 hours
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 V
Removing the Battery
WARNING
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
36
Advertisement
Table of Contents
