Suspension Tester Sdl 43X - Bosch BSA 43 Series Original Instructions Manual

5.2.3

Suspension tester SDL 43x

i
The suspension tester is always provided with axle load scales.
Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Tester/test routine selected.
2. Drive onto the suspension tester with
the axle to be measured first and keep-
ing the vehicle straight. Press the brake
to stop the vehicle moving.
i
If the suspension tester is only being
used to measure the axle weight for a
brake test:
3. Store axle weight.
Robert Bosch GmbH
Manual mode (normal operation) | BSA 43xx | 53
Remote control unit Result / Display
 Left: "Suspension tester" device symbol.
 Right: Drive-on prompt.
 Axle to be measured is positioned in
suspension tester.
 Screen displays axle load (kg).
 Ready for chassis measurement.
 Axle weight is stored.
 Continue with step 6.
+
Store front axle load
+
Store rear axle load
en
|
1 691 606 210 2015-07-29