Schedule Timer; Rbc-Ams41E - Toshiba RBC-EXW21E2 Quick Reference

4. Schedule Timer

Type Name

: RBC-AMS41E

Part No. : 43166012
Substitution : NO
Type of Remote : Schedule timer
: SX-A5EE
Reference
Product used : VRF
Note :
120
How to wire the remote controller
Connection diagram
Terminal block
Remote controller wiring
for remote
(procured on site)
controller wiring
in indoor unit
* Terminals A and B are non-polar
Basic wiring diagram
Remote controller
(Header)
Terminal block for
remote controller wiring
Earth
Category
DI
SDI
MiNi-SMMS
SMMS
SHRM
SMMS-i
SHRM-i
16
2
* AWG20 (Use 0.5 mm
* Can not use the closed end
wire joint.
* Use UL wires rated 300 V.
Remote controller
Remote controller
terminal block
Remote controller
(Follower)
(sold
separately)
Remote
controller wire
(procured on site)
Indoor
unit
Remote controller
(inside, rear)
Remote controller test run setup
1. Push and hold the
unitil "TEST" appears in the LCD display, then press the
button.
• "TEST" appers in LCD display during the test run.
• Temperature adjustment is not possible while "TEST" is
displayd. The test run applies considerable load on the
machine; therefore, it is recommended not to use the
test mode beyond necessity
2. The test mode should be used in either HEAT or COOL
mode.
NOTE: The outdoor unit will not operate for approx.
3 minutes after power up, or the operation will stop.
3. Be sure the "TEST" indication in the LCD disappeared by
pushing the
(The remote controller has a 60-minute off timer function
to prevent continuous test run)
Selecting the operation when the
power is restored after a power outage
OK
Follow the steps below to select and set the operation
OK
status of the air conditioner when power is restored after a
OK
power outage has occurred during a scheduled operation.
OK
1. Hold down the
OK
(This step can be performed whether the air conditioner
is running or shut down.)
OK
OK
2. Push the TEMP.
3. Push the TIME
00 00
data to
4. Push the
successfully if the display stops blinking and lights up.
5. Push the
00 00
* (factory setting):
No settings are sent when the power is restored,
and the scheduled operation is resumed as soon
as the program time is reached after the power has
wire)
been restored.
00 01
* :If there was a program which was to have run
during the power outage, it is resumed in
accordance with what was programmed. If there is
no program, operation resumes in accordance with
what was being performed prior to the power outage.
– 18 –
Multiple wiring diagram
DIP switch DIP switch DIP switch
Header remote Header remote Follower remote
control/scheduled control/timer control/scheduled
timer operation operation timer operation
button for 4 seconds or more
button agin after exiting the test mode.
+ buttons for at least 4 seconds.
/ buttons, and set code No.14.
/ buttons, and set the setting
00 01
(factory setting) or .
button. The setting data is entered
button.
DIP switch
Follower remote
control/no timer
function