GE Hydran M2-X Installation Manual page 25

Hydran* M2-X Installation Guide
Insert the sensor cable connector into the sensor connector.
1.
Rotate connector clockwise (approximately 1/8 turn).
2.
Position the enclosure and push it on to the sensor; taking
3.
care not to squeeze the sensor cable between the sensor and
the enclosure.
Apply a thin layer of anti-seize lubricant to the threads of the
4.
M2-X base plate before attaching the brass ring.
Install the sensor clamp and tighten it using the supplied
5.
spanner wrench.
Tighten set screw using 1/16-in Allen key.
6.
MA-028 Rev. 2.1, 11-Jun-20
Figure 20: Installing the Hydran M2-X on the Sensor
Connect ground wire
to ground lug using a
10-6 AWG copper
Figure 21: Grounding the Hydran M2-X Enclosure
Page 25