No.
Name
*3
4)
Group number setting
Switch
*3
5)
Network number setting
switch
6)
Connector
7)
Mounting screw
8)
Connector
9)
Mounting screw
10)
Interface connector
11)
Extension connector
*1 : Even if the station No. settings are overlapped, the M/S.E. LED may
not be on, depending on the line status or cable connection status. It
is recommended to confirm the settings by performing a visual
check and executing a confirmation test.
*2 : If no terminal resistors are attached, this may be always on.
(This is not a network error (specific to A9GT-QJ71BR13.))
*3 : Make sure to reset the GOT after changing the settings. However,
this does not apply when 2) mode setting switch is changed to any
of "D" to "F".
*4 : The GOT does not use a group number. Set as 0 (No group
designation).
Group number setting (factory setting at time of shipping: 0)
<Setting range>
0
: No group setting (Fixed)
Network number setting
(factory setting at time of shipping: 1)
<Setting range>
1 to 239
: Network number
Other than 1 to 239: Setting error (SW.E LED lamp is lit)
A9GT-QJ71LP23 : Connect the optical fiber cable
A9GT-QJ71BR13 : Connect the F-type connector
Screw for mounting to the GT15-75IF900
Connector for connection to the GT15-75IF900
Mounting screw to be fixed with the GOT main unit
Connector connecting to GOT
Connector connecting with A9GT-QJ71LP23/
A9GT-QJ71BR13
8
Details
*4