Automatic Switch-Off; Cleaning; Self-Cleaning Function - Silvercrest SDB 2400 F4 Operating Instructions Manual

Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the iron
from heating up.
If the iron is resting on the sole of the iron
30 seconds, you will hear a warning beep and the control lamp for the
automatic switch-off
the automatic switch-off, lift up the iron and move it gently from side to side.
The control lamp for the automatic switch-off
up again.
If the iron is on its base
warning beep and the control lamp for the automatic switch-off
will stop heating up. To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side. The control lamp for the automatic switch-off
goes out and the iron will heat up again.
NOTE
► The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! This is merely intended to reduce the fire hazard
if you forget to switch off the iron!

Cleaning

Self-cleaning function

1) Fill the water tank to the "MAX" marking.
2) Insert the plug into the mains power socket.
3) Move the temperature control
4) Set the steam control
5) Allow the steam iron to heat up until the temperature control lamp
and then lights up again.
6) Hold the steam iron horizontally over a suitable container.
7) Press the self-clean button
and forth a little. Steam and boiling water will flow from the steam exit holes in
the sole of the iron
8) Release the self-clean button
used up.
9) Dry the sole of the iron
back and forth several times over a towel or an old piece of material.
10) Allow the steam iron to cool down before placing it in storage.
■ 24 │ GB │ IE
and is not moved for about
will flash. The iron will stop heating up. To deactivate
and is not moved for about 8 minutes, there will be a
to the "MAX" position.
to maximum steam power.
and keep it pressed. Move the steam iron back
. Any impurities that may be present are flushed out.
as soon as all of the water in the water tank is
thoroughly. To do this, move the sole of the iron
goes out and the iron will heat
flashes. The iron
SDB 2400 F4
goes out