Panasonic SF2B Series Instruction Manual page 26

● The cable for series connection (SF2B-CSL□) cannot be extended.
● When the cable for series connection (SF2B-CSL□) is inserted to the main
sensor (this device) and the sub sensor exclusive for series connection
(SF2B-□SL), take care of the following. If inserted without care, the connector
pins may bend.
1) Do not pull the cables before tightening the M3 screws.
Good
2) Do not insert the connector incorrectly and tighten the M3 screws.
Good
<Reference>
There is no difference in the cable for series connection for the emitter and the receiver.
The length of the cable for series connection differs depending on the model No.
Model No. Cable Length (mm)
SF2B-CSL01
SF2B-CSL05
<Dismantling the cable for series connection>
1. For dismantling the cable for series connection, follow the above procedure of <Construct-
ing method for the series connection> in reverse.
26
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
Fixed with M3 screws
No gap
100
500
Not good
Not fixed with M3 screws
Not good
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Gap